CONNECTORS

Feed Power Connector (2 Pieces): Feeds the power coming from the Transformer to the Electrical Rail.

Put each wire from the transformer into each piece of the Feed Power Connector fastening them by the hexagon screws. Hexagon key: 2.0mm. Then take the two pieces together and slide them into the rail, mount them by fastening the hexagon screws. Hexagon key: 2.0mm.

Conductive Joiner Connector (2 Pieces): Transmits the power from one rail to the next.

Slide the two pieces together into the rail, mount the next rail, position the middle of the Conductive Joiner Connector right in the union of the two rails, mount the pieces by fastening the four hexagon screws, two on one rail and two on the other. Hexagon key : 2.5mm.

Supporter Connectors (2 Pieces): Transmit the power from the rail to the Rods or Cables and support through these, the weight of the picture.

Slide the two Supporter Connectors into the rail, position them separeted by the same distance between the hangers of the frame of the picture, fix them by turning.

The Rods or Cables slid into the Support Connectors are fastening by the hexagon screws. Hexagon key: 2.5mm.

Self Adjustable Supporter Connectors ( 2 Pieces ): Transmit the power from the rail to the Rods or Cables and support through these, the weight of the picture.

Slide the two Supporter Connectors into the rail, position them separeted by the same distance between the hangers of the frame of the picture, fix them by turning.

To place the Rods or Cables, simply push them into the Supporter Connectors.

To take out the Rods or Cables simply push up the lower part of the Supporter Connectors and pull them out.